JS concrete mixer matters need to pay attention when debugging

wendy2015

Mixing machine, ashaft with blades rotating in the cylinder or tank, mixing the various rawmaterials, making it a mixture or a suitable consistency of machines. There arecompulsory mixing machine, single horizontal shaft mixing machine, twin-shaft mixingmachine. When mixing machine debugging, you should pay attention thefollowing points.

1, to check the lubricationof the gear box and various lubricants adequacy is good.
2. Check the power supply voltage: Rated voltage is 380 volts, the error is ±10%.
3. Check the motor and electrical components wiring is solid, reliable powerdistribution box housing must be grounded. Power distribution box neutral must findN terminal block, all lines should be properly resettled, while working toprevent accidents caused by crushing hit.
4, start stirring motor, two axle direction of rotation should be consistentwith signs indicating directions, such as the wrong direction, the power wiringshould be changed
5, boot volume field motor lifting hopper, hopper raised to unloading position,should automatically stop, Doumen automatically opens.

6, start unloadingmechanism, the discharge door opening and closing should be accurate place. Startthe pump to draw water, water supply systems should operate normally.
7, according to the desired ratio of concrete to determine the amount of water,and adjusted to the appropriate water supply time relay time. Start stirring motorrunning.
8, close the discharge gate, adding the desired mix within the hopper, lifting hopper.

9, stirring 25-35seconds, start unloading discharge door.
10, in the above commissioning process, if found to be normal, you should immediatelystop inspection, troubleshooting, and then test again, you know normal. The newmachine running the liner after use, and elsewhere to deal with bolts and nuts allday, checking the tightening. Parts of transmission lubrication greaselubrication.