|
1. concrete mixer should be set at a flatposition, with square wooden paving around the axle of the tire put highoverhead, avoid walking in motion occurs.
2. concrete mixers secondary leakage protection should be implemented after thepower is turned on before work must be carefully examined by the turn that theempty test qualified before use. Commissioning tests should be mixed with drumspeed is appropriate, under normal circumstances, the proportion of emptyvehicle speed (after charging) slightly faster 2 to 3 revolutions, such as adifference of more, should be adjusted to move the wheel and drive wheel ratio.
3. the direction of rotation of mixing drum should be consistent with directionof the arrow, as inconsistent with reality, should be corrected electricalwiring.
4. Check the drive clutch and brake is flexible and reliable, wire rope fordamage, pulley track is good, there is accessibility and various parts of thelubrication and other surrounding circumstances.
5.boot, always pay attention to the various components of the concrete mixeroperation is normal. Shutdown, always check whether a clincher concrete mixerblades, whether or loose screws have knocked.
6. when the concrete mixing is completed or is expected to be more thanexpected 1 stop outside the net, use stones and water poured into the shakingcylinder, power rotation, to stick to the barrel of the mortar dischargedcompletely clean after flushing. You may not have water in the barrel, in orderto avoid the barrel and leaf rust. It should also clean up outside the mixingtube fouling, the mechanical clean intact.
7. after work and do not stop, it should wind up its power, and lock the switchbox to ensure safety.
| 
Post time 21-8-2015 11:00 AM
变色卡
